CLEANX MOP FREE

Maintenance Procedures Showers, Walls & joinery:ĭo not wash or wet X-Bond surface for the first week after application not even with water. If floor is still dirty repeat the above process. Regularly use wet/dry vacuum to remove residue, dirt and water.Ħ. Scrub floor with a floor scrubber using a white scrubbing pad.Ĥ. Use a mop to generously apply this mixture to floor.ģ. Dilution ratio: 1:20 (One part Stone Soap to 20 parts water).Ģ. Mix Stone Soap with clean, hot water in a bucket. Option 2 - Stone Soap Application – using scrubbing machine.ġ.

Dilution ratio of 1:10 (one part Stone Soap to 10 parts of water) is recommended for a stronger solution. Note: A stronger solution of Stone Soap can be used to clean spills ranging from acidic condiments to animal urine. Rinse floor with clean water using a clean mop for internal & stiff bristle brush or hosing down for external.Ĩ. Rinse mop as needed and change solution at least every 200m2 or as needed for large areas.ħ. For stubborn scuff marks, use a low abrasive scrubbing pad (white in colour)Ħ. Abrasive materials are not recommended to remove scuffs or other marks. For external areas Scrub area with stiff bristle broom for rough surfaces or a sponge for smooth surfaces. For scuffs or other marks apply Stone Soap mixture to problem area with a clean rag, sponge or synthetic mop.

Mix Stone Soap with water to the above ratio in a clean bucket (alternatively use similar cleaning detergent it should be neutral without stripping agents).ģ. Option 1 - Stone Soap Application – using a mop.Ģ. Dilution ratio is 1:20 (one part Stone Soap to 20 parts clean hot water). Daily/Weekly Maintenance using Stone Soap:Ĭlean floor as usual with a broom or a vacuum. To keep your floors from Alternative Surfaces in a good, maintained condition please follow the below maintenance procedures.

External areas - use low-pressure washing equipment or simply hose down.

Do not use steam mops as this can soften and effect sealers.

Some liquids (for example nail polish remover, citrus, urine, oil) can stain your surface and need to be removed as quickly as possible.

Clean up all spills and semi-solids as soon as possible.

A clean microfiber dust mop is very effective at removing dirt on our surfaces.

CLEANX MOP FREE

Keep the floors free of any sand, grit or larger debris, as these can be abrasive to the surface.

If using rubber products such as rubber backed mats or rubber floor protectors please lift to clean underneath regularly to ensure there is no moisture left underneath it. Walk-off mats and rugs in high traffic areas and at the entrances will catch dirt before it reaches the floor.Work-station mats which are not rubber-backed are recommended to prevent desk chair damage. Felt protectors on furniture will reduce scratching to the surface.Any rubber products such as rubber-backed mats or rubber floor protectors can permanently mark the surface.Natural Shield sealed surfaces – Low abrasive detergents or Stone Soap can be used as per Manufacturer’s instructions.Satin Stone sealed surfaces – Stone Soap & all common disinfectants can be used as per Manufacturer’s instructions.SEMCO Stone Soap is a general-purpose cleaner however will not disinfect a surface.Avoid detergents with a solvent-based acetone of a concentrate exceeding 50 %. Most household, commercial & industrial detergents may be used. Cleaning of the surface can vary depending on the contents of material spilled, foot traffic from dirt or pavement.This allows sealers to dry/cure completely. Do not wash X-Bond surface for the first week after application not even with water.

Cleanx mop